POLINI Hi-Speed II Bosch Smart System Ontgrenzer - E-Bike

THIS ITEM SHALL BE USED IN ACCORDANCE WITH THE NATIONAL LAWS CONCERNING TRAFFIC; IT CANNOT BE USED ON PUBLIC ROAD.

Warnings and instructions inside. Polini Hi-Speed is an electronic device studied for E-bike motors with the aim to increase the pedal assist mode exploiting at all the performance that the motor can offer. The assembly takes only a few minutes. It does not require any setting because it is self-adjusting. The device does not require any battery since it is self-recharging. The speedometer will always show half of the actual speed, and the same for the Kms travelled. To know speed and kms travelled it is enough to double the figures.

HI-SPEED ACTIVATION/DEACTIVATION

Always active after configuration. As soon as it is installed, Hi-Speed is activated immediately; The display shows 5.0 km/h to confirm that Hi-Speed is in operation and with no speed limit.

The actual speed is indicated by the last 2 figures on the display, for example, 14.2 corresponds to 42 km/h. Every time the bike is turned ON, the display will show the set maximum speed limit. You can calibrate the wheel, operating mode and change the speed limits of the Hi-Speed using the setup procedure in the instruction manual.

IMPORTANT NOTE:

• In Bosch Smart System systems equipped with speed sensor cable (i.e. without magnet in the rim) it is possible to increase the high speed and this Hi-Speed is valid.
• Bosch Smart Systems equipped with rim magnet (located in the rear wheel valve) do not have a speed sensor cable. Therefore, it is NOT possible to increase the high speed and this Hi-Speed is NOT valid.